EVAPORATIVE COOLING PAD SYSTEM
Kool-Cel pads are cellulose cooling cells 4" and 6" deep, 12" wide and available in 12" increments from 24" to 72" tall with two pieces of 4" combined to make 84" and 96" tall pads. The cooling cells are made from a specially formulated cellulose paper impregnated with insoluble anti-rot salts. It is designed with an exclusive cross-fluted configuration which induces highly turbulent mixing inside the pad between the water and the air, and contributes to the evaporative efficiency. The cross-fluted design makes Kool-Cel a strong self-supporting pad with high evaporative efficiency and low pressure drop (resistance to air flow).
A face velocity of 250 feet per minute for 4" and 400 feet per minute for 6" is recommended for the most economical cost
Sizing Kool-Cel Pad
Determine Total Summer Cooling Required in CFM, then divide by velocity to obtain pad area in square feet. The pad area divided by the length will determine the height in feet.
4" KOOL-CEL PAD
The 4" Kool-Cel pad is constructed with air flow at equal 45° angles which allows air flow to enter from either side of the pad.
6" CELDEK PAD
The 6" Celdek pad contains flutes organized in two angles, one with steep pitch and the other less pitched. The air must enter the pad from the side with the steep pitch.
Optional coating on one or both sides of the pads reduces algae growth and enables easy pad cleaning and maintenance.
Following information is available with order upon request:
- Maintenance Guide
- Approved products and chemicals for use with pads
- Edge Coating Treatment
- Mineral Buildup Prevention Guide
- Particulate Removal Capabilities