DELTA-T HEATING SYSTEMS FOR
ALL TYPES OF GREENHOUSES
Delta T Solutions hot water heating systems utilize the physics
of heat to efficiently heat the plants. Placing the heat under the plants
the heat source to react faster to temperature changes at the plant
level. Heating from below also offers a more consistent temperature, better
plant quality and lower heating costs.
DELTA T Heating Systems:
- Heat Exchangers
- EPDM Rubber Tube Bench-Top Heating
- EPDM Rubber Tube In-Ground Heating
- High Density Polyethylene Concrete
- Floor Heating
- Hot Water Boilers
- Twin-Fin Aluminum Tube heating
- Multi-Fin Aluminum Tube heating
- Hot Water unit Heaters
- Warm Water Irrigation
- One Source System Responsibility
Five Heat Componets for Better Plant Growth
- HEAT SOURCE: Delta T can design a heat source specifically
for the heat loss of the structure or the output of the radiation. The
source can use various types of fuels ranging from fuel oil, natural
or propane gas, to heat exchangers using steam, waste heat from
electric plants or geothermal wells.
- AIR AND WATER CONTROLS: Delta
T can help with the controls which regulate system water pressure
and eliminate air trapped in the system.
As simple as it sounds these components are critical parts of the
- PUMP: Delta T provides pumps that transport the
water through the piping from the heat source to the radiation system.
The system controls
then monitor the soil/plant temperature and regulate the pumps and
heat sources accordingly.
- SYSTEM PIPING: The system piping carries
the water from the heat source to the radiation system. In a low
temperature system the piping
can be PVC, but in a higher temperature system it must be copper or
steel. Delta T Solutions can supply any or all of these to make a
- RADIATION: Being the most important component,
radiation refers to the material the heat flows through to the crops.
Delta T selects
materials for each system based on materials that make each particular
system the most efficient. Your specific needs are taken into account
with regard to heat loss requirements, bench or bed configuration,
type of crop and other factors such as geographic location. It may
to use more than one type of radiation to satisfy the heating requirements
of the greenhouse.
Delta T designs all aspects of the heating system so it can be
installed by either a contractor or owner, depending on the type of
Installation instructions and diagrams illustrating pipe size,
location and control
wiring are included to make the installation simple.
Delta T provides up-to-date electronic controls to monitor the
temperature in the greenhouse and soil. Delta T can design the
system to be
controlled by an environmental control computer system that
will regulate all
aspects of the greenhouse environment. All components of a system
can be designed
by Delta T to provide optimal heating results.
Hot Water Heating Systems
Delta T hot water heating systems utilize the physics of heat to efficiently heat plants. Putting the heat under the plant allows the heat source to react faster to temperature changes at the plant level. Heating from below offers a more constant temperature, better plant quality, and lowers heating costs.
For a quotation on a Delta-T Solution, please use our quotation form.
More infomation about Heating Systems for all Types of Greenhouses