Benches Dura Dura Bench Original Plastic Greenhouse Bench Top The Dura-Bench Original was introduced in 2001 as a plastic bench top to replace wood, wire and expanded metal. The Dura-Bench Original is heavier in weight and encompasses smaller square holes for more surface area. This product is peak load tested at 630 lbs. DESIGN / FEATURES 2’x 4′ (8 sq.ft., nominal) high impact abrasion resistant polypropylene plastic panel – weight 6.35 lbs each 1.1 ” x 1.1″ square holes Two unique styles – Overlap and Non-Overlap versions The Overlap version interconnects with tabs on the 4′ sides and overlaps on the 2′ ends The Non-Overlap version interconnects with tabs on the 4′ sides and butts up to the 2′ ends (10) Pre-molded screw holes per panel for attaching to substructure with stainless steel screws UNIQUE BENEFITS Durable, Flat, Smooth Surface Smaller Hole Openings Heavier Easier to Install Easier to Disinfect UV Protection Longer Lasting Rot, Splinter & Decay Proof Rust, Corrosion & Deforming Proof TABLE LAYOUT / DESIGN Dura-Bench Ultra panels allow for any combination of bench sizes Overlap version is primarily used in 2′, 3′, 5′, 6′, 7′, and 8′ wide benches – the 4′ length lays down going in the same direction as the length of the bench Non-Overlap version is used primarily on 4′ wide benches – the 4′ length lays down going across the width of the bench Substructure frame can be made from metal, wood, or pipe Substructure frame cross supports are placed on incremental intervals of 16″ or 24″ centers based on the weight of the plants per sq foot REPLACES Expanded Metal Wood / Lattice Wire Most greenhouse bench manufacturers and those in current use have outside dimensions, for example, of 2, 4, 5, 6 ft and have raised edges such as welded wire and expanded metal are sized smaller to fit inside the bench. THE DURA BENCH PRODUCTS ARE EXACTLY 2 FT X 4 FT SECTIONS. We offer ready made benches designed for the Dura Bench, meaning that the bench holds the 2 x 4 ft insert and is slightly larger to accommodate the product.